Logo

U3599 Engine Trouble Code

Meaning of U3599 engine trouble code is a kind of network trouble code and U3599 if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.

U3599 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U3599 code is occuring now you should check U3599 repair processes.
Now don't ask yourself; What should you do with U3599 code ?
The solution is here :

U3599 Possible Solution:

U3599 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U3599 Code Meaning :

U 3 5 9 9
OBD-II Diagnostic Network (U) Trouble Code For Engine Ignition System Or Misfire Fuel Composition Sensor Circuit Malfunction Crankshaft Position Sensor A Circuit Malfunction Reverse Input Circuit

The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.

U3599 OBD-II Diagnostic Network (U) Trouble Code Description

U3599 engine trouble code is about Reverse Input Circuit.

Main reason For U3599 Code

The reason of U3599 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

U3599 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.